Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: strip milling progress, then ...
By:Jerry Siegel
Date: 11/6/2001, 4:28 pm
In Response To: Re: Strip: strip milling progress, then ... (Bob Deutsch)

The saw blade runs on a seperate arbor from the motor and is usually powered via a belt (some use gears). They are more powerfull and quieter than direct drive models. And morre accurate! Figure at least $600, with $1500 getting you something to brag about. Woodcraft has a Delta on sale for $1699, that includes $300 in accessories.

Woodcraft

Messages In This Thread

Strip: strip milling progress, then ...
Brian Ramoly -- 11/6/2001, 3:06 pm
Re: Strip: strip milling progress, then ...
Simon Baillie -- 11/7/2001, 8:36 pm
Re: Strip: strip milling progress, then ...
Brian Ramoly -- 11/7/2001, 12:57 pm
Re: Strip: strip milling progress, then ...
Bob Deutsch -- 11/6/2001, 4:09 pm
Re: Strip: strip milling progress, then ...
Toby Ebens -- 11/6/2001, 6:34 pm
Re: Strip: strip milling progress, then ...
Erich Eppert -- 11/6/2001, 10:59 pm
Re: Tune-up Time Perhaps ??
Rehd -- 11/6/2001, 11:39 pm
Re: Tune-up Time Perhaps ??
Erich Eppert -- 11/8/2001, 10:21 am
Re: Excellent Buy O.T.
Rehd -- 11/8/2001, 4:52 pm
Re: Strip: strip milling progress, then ...
Jerry Siegel -- 11/6/2001, 4:05 pm
Re: Strip: strip milling progress, then ...
Bob Deutsch -- 11/6/2001, 4:11 pm
Re: Strip: strip milling progress, then ...
Jerry Siegel -- 11/6/2001, 4:28 pm