Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: dealing with epoxy runs
By:Bill Hamm
Date: 2/2/2011, 1:52 am
In Response To: Re: Strip: dealing with epoxy runs (Charlie)

: A cabinet/card scraper for certain. Nothing is better. If you don't
: know how to do a turned edge you'll need a set of instructions,
: a mill file, a turning steel and some practice. But even if you
: don't get a sharp edge it will work on green epoxy.

Round shank screwdriver will work in a pinch, specially when you can't find the steel ;)

Bill H.

Messages In This Thread

Strip: dealing with epoxy runs
Todd O -- 2/1/2011, 2:47 pm
Re: Strip: dealing with epoxy runs
Mike Savage -- 2/1/2011, 3:01 pm
Re: Strip: dealing with epoxy runs
Allan -- 2/1/2011, 3:52 pm
Re: Strip: dealing with epoxy runs
Todd O -- 2/1/2011, 9:27 pm
Re: Strip: dealing with epoxy runs
Allan -- 2/1/2011, 10:02 pm
Re: Strip: dealing with epoxy runs
Todd O -- 2/1/2011, 10:44 pm
Re: Strip: dealing with epoxy runs
Allan -- 2/1/2011, 10:59 pm
Re: Strip: dealing with epoxy runs
Bill Hamm -- 2/2/2011, 1:51 am
There's scrapers and scrapers
Jay Babina -- 2/2/2011, 8:18 am
Re: Strip: dealing with epoxy runs
Charlie -- 2/1/2011, 3:57 pm
Re: Strip: dealing with epoxy runs *PIC*
Tony Olsen -- 2/1/2011, 6:07 pm
Re: Strip: dealing with epoxy runs
Bill Hamm -- 2/2/2011, 1:52 am
Re: Strip: dealing with epoxy runs
Todd O -- 2/2/2011, 2:52 pm
Re: Strip: dealing with epoxy runs
Bill Hamm -- 2/2/2011, 3:53 pm
Re: Strip: dealing with epoxy runs
Todd O -- 2/2/2011, 8:57 pm
Re: Strip: dealing with epoxy runs
Bill Hamm -- 2/3/2011, 2:37 am
Re: Strip: dealing with epoxy runs
Todd O -- 2/3/2011, 10:45 am
Re: Strip: dealing with epoxy runs
Bill Hamm -- 2/3/2011, 11:26 am
Re: Strip: dealing with epoxy runs
Eric -- 2/2/2011, 1:21 pm
Re: Strip: dealing with epoxy runs
Etienne Muller - ireland -- 2/3/2011, 3:14 pm
epoxy runs - a better alternative
mick allen -- 2/4/2011, 9:41 pm