Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Gap Between Deck and Hull
By:Ric Moodie
Date: 2/16/2011, 8:52 pm
In Response To: Strip: Gap Between Deck and Hull (G New)

: Hi all,

: I am almost ready to glass the outside of my boat. I have a gap of
: say 1/4 inch in some areas (mostlly near the ends where the
: curve is the greatest) between the deck and the hull. In the
: present un-glassed state it is easy to flex the two pieces until
: they form a good mating surface. Will I still be able to flex
: this gap closed when the deck and hull are glassed inside and
: out? First time builder here.

: Greg New

If it was mine I would try to flex the two together and use hot glue or whatever so as to get at least the outside glass on while the two pieces were mated. I did not find it a whole lot of fun having to deal with that kind of gap so I think it's worth doing what you can to minimize them before they get locked in by glassing.

Ric

Messages In This Thread

Strip: Gap Between Deck and Hull
G New -- 2/16/2011, 7:31 pm
Re: Strip: Gap Between Deck and Hull
Allan -- 2/16/2011, 7:44 pm
Re: Strip: Gap Between Deck and Hull
Ric Moodie -- 2/16/2011, 8:52 pm
Re: Strip: Gap Between Deck and Hull
G New -- 2/16/2011, 10:27 pm
Re: Strip: Gap Between Deck and Hull
Paul G. Jacobson -- 2/17/2011, 11:39 am