Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Help needed with stock power feeder
By:Chris Reyes
Date: 11/6/2017, 4:48 pm

Hello,
How is this secured to the table saw surface? The bottom picture looks as if there might be a catch screwed to the bottom of the plywood? So the action of the feeder pulls the setup up and to tight to the fence by transferring friction through the stock, correct?
Also, no feather board on this setup?

Thanks!

Messages In This Thread

Strip: Help needed with stock power feeder
Greg Galloway -- 10/18/2013, 1:20 pm
Re: Strip: Help needed with stock power feeder *PIC*
Etienne Muller -- 10/18/2013, 2:08 pm
Re: Strip: Help needed with stock power feeder
Mike Bielski -- 10/20/2013, 12:54 pm
Re: Strip: Help needed with stock power feeder
Etienne Muller -- 10/20/2013, 2:01 pm
Re: Strip: Help needed with stock power feeder *PIC*
Greg Galloway -- 10/20/2013, 9:17 pm
Re: Strip: Help needed with stock power feeder *PIC*
woodman -- 10/27/2013, 9:30 pm
Re: Strip: Help needed with stock power feeder
Bill Hamm -- 10/31/2013, 9:19 pm
Re: Strip: Help needed with stock power feeder
Chris Reyes -- 11/6/2017, 4:48 pm
Re: Strip: Help needed with stock power feeder
M A Bielski -- 11/8/2017, 12:31 am
Re: Strip: Help needed with stock power feeder *PIC*
Nick Schade - Guillemot Kayaks -- 11/8/2017, 7:21 am
Re: Strip: Help needed with stock power feeder
Chris Reyes -- 11/10/2017, 1:21 pm
Re: Strip: Help needed with stock power feeder *PIC*
Jim Schaffer -- 10/19/2013, 7:54 pm
Re: Strip: Help needed with stock power feeder *PIC*
Jim Schaffer -- 10/19/2013, 8:03 pm