Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Fiberglass Tape Edge
By:Al Bratton
Date: 3/29/2000, 8:02 am
In Response To: Fiberglass Tape Edge (Mike Brack)

What we do at our shop is coat the hull first, apply tape down the center seam, then after it's cured we sandown the edges careful not to sand into the rest of the hull. Then we lay the final sheet of glass and start that part of the project. But this is on stripper kayaks. AL

Woodstrip Watercraft Co.

Messages In This Thread

Fiberglass Tape Edge
Mike Brack -- 3/28/2000, 9:36 pm
Re: Fiberglass Tape Edge
Vaclav -- 3/29/2000, 4:48 pm
Re: Fiberglass Tape Edge
Al Bratton -- 3/29/2000, 8:02 am
Re: Fiberglass Tape Edge
Mike Hanks -- 3/29/2000, 1:28 am
Re: Fiberglass Tape Edge
Robert -- 3/29/2000, 6:07 am
Re: Fiberglass Tape Edge
Spidey -- 3/28/2000, 10:48 pm
Re: Fiberglass Tape Edge
Jerry -- 3/28/2000, 9:58 pm
Re: Fiberglass Tape Edge
Chris Dore -- 3/28/2000, 9:44 pm
Re: Fiberglass Tape Edge
lee -- 3/28/2000, 9:51 pm
Re: Fiberglass Tape Edge
Shawn Baker -- 3/28/2000, 9:39 pm