: I have done it on several of my boats. i purchased 3/8" brass tubing
: from my local scrap metal dealer and sawed it in half lengthwise. I then
: drilled countersunk holes (using a centerdrill) to accept #4 or #6 brass
: oval head screws. I then screwed it over the end of the boat and bedded it
: in 3M-5200 sealant. I bent the brass around the tip of the bow of my boats
: and down the stem and back along the keel about 4 feet, same on the stern.

: the photo shows the brass rub stip I installed on an OuterIsland.

Eric,

Pretty impressive bow action. After the link to yr site you have somtthing called a stealth rudder - what is it? Like extreme interface's?

-mick