Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Thin kerf blade wobble
By:Pete Roszyk
Date: 8/9/2001, 7:35 pm
In Response To: Re: Cutting Strips (Rehd)

Hi there.

Cheap and/or lousy thin kerf blades wobble, and not just from heat buildup. Especially if the teeth points on one side or the other have hit something hard like metal or the QA/QC guy at the factory was napping. You tend to get what you pay for here.

Pete Roszyk,
In Snohmish, WA

Messages In This Thread

Cutting Strips
Jim Martin -- 8/9/2001, 10:04 am
Re: Cutting Strips
scott e. davis -- 8/9/2001, 1:25 pm
Re: Cutting Strips
Jim Kozel -- 8/9/2001, 2:35 pm
Re: Cutting Strips
scott e. davis -- 8/10/2001, 1:34 pm
Re: Cutting Strips
Rehd -- 8/9/2001, 3:46 pm
Thin kerf blade wobble
Pete Roszyk -- 8/9/2001, 7:35 pm
Re: Thin kerf blade wobble
daren neufeld -- 8/9/2001, 8:27 pm
Re: Thin kerf blade wobble
Ric Altfather -- 8/10/2001, 2:04 pm
Veritas Saw Blade Truing Disk
Kenny Too Slow -- 8/10/2001, 7:12 pm
Cutting for uniformity
!RUSS -- 8/9/2001, 12:53 pm
Re: Cutting Strips
Brian McM -- 8/9/2001, 11:53 am
Re: Cutting Strips
mark stevens -- 8/12/2001, 4:51 pm
Re: Cutting Strips
Rehd -- 8/9/2001, 11:41 am
Re: Cutting Strips
Stan Woronko -- 8/9/2001, 11:19 am