Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: end pour question ??
By:Terry
Date: 9/5/2001, 9:14 pm
In Response To: Re: end pour question ?? (Bill Price)

: Hey bud!

: Ken is right about the tape softening up with epoxy heat. Happened to me on
: one of our Terns. It was a major mess. You might consider a piece of
: tubing through the hole. People here have used PVC, copper, or wood tubes.
: If you epoxy it in place first it should seal up any gaps.

: Bill

Yo Bill,
Are you meaning to drill the hole, fasten a tube then endpour?
That would take a bit less resin? yes/no?

Regards Terry Thx Ben,Ken,Bill& Severne

Messages In This Thread

end pour question ??
Terry -- 9/5/2001, 10:43 am
Re: end pour question ??
Severne -- 9/5/2001, 7:40 pm
Re: end pour question ??
Bill Price -- 9/5/2001, 6:25 pm
Re: end pour question ??
Terry -- 9/5/2001, 9:14 pm
Re: end pour question ??
Bill Price -- 9/5/2001, 11:54 pm
Re: end pour question ??
Ben Staley -- 9/5/2001, 11:17 am
Re: end pour question ??
Ken Sutherland -- 9/5/2001, 4:26 pm