Boat Building Forum
Find advice on all aspects of building your own kayak, canoe or any lightweight boats
Re: Smoothing inside seam rough edge?
In Response To: Smoothing inside seam rough edge? (Richard Boyle)
: The edges of the inside seam of my Guillemot have a rough ridge which could
: cause damage to gear, floatbags, etc.
: Any ideas for smoothing it out, especially towards the ends where it is hard
: to reach?
Really coarse sand paper (36 grit) would probably due the job. Tape it to a foam block and attach the block to the end of a stick. You could also paint on a little more epoxy. Is it really that rough. I have not had any problem with the tape puncturing dry bags.
Messages In This Thread
- Smoothing inside seam rough edge?
Richard Boyle -- 9/6/2001, 9:52 am- Re: Smoothing inside seam rough edge?
Nick Schade - Guillemot Kayaks -- 9/6/2001, 3:56 pm- Re: Smoothing inside seam rough edge?
mark stevens -- 9/6/2001, 9:15 pm
- Dremel-on-a-stick?
Dean Trexel -- 9/6/2001, 3:19 pm- Re: Smoothing inside seam rough edge?
Elliott -- 9/6/2001, 10:45 am - Re: Smoothing inside seam rough edge?
- Re: Smoothing inside seam rough edge?
