Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: First Stripper - Finally Launched
By:100GRIT
Date: 10/10/2001, 6:05 pm
In Response To: First Stripper - Finally Launched *Pic* (Ted Henry)

Hey Ted.
thats a fine looking boat and the web page is killer.Question,when you cut out the section for the veneer do you stay within the first layer of the plywood and is there a variety of sizes(thickness),I know zip about veneer but sure like the end results.

thanks

100GRIT

Messages In This Thread

First Stripper - Finally Launched *Pic*
Ted Henry -- 10/10/2001, 5:13 pm
BRAVO TED! *NM*
Jim McCool -- 10/12/2001, 2:35 pm
Beautiful job *NM*
Nick Schade - Guillemot Kayaks -- 10/11/2001, 9:42 am
Re: Holy Mackerel!
Ross Leidy -- 10/11/2001, 8:54 am
Copywright that photo and sell posters. Great. *NM*
John Monfoe -- 10/11/2001, 5:45 am
Re: First Stripper - Finally Launched
Bob Deutsch -- 10/10/2001, 9:59 pm
Re: First Stripper - Finally Launched
daren neufeld -- 10/10/2001, 8:41 pm
Super!
John Schroeder -- 10/10/2001, 8:48 pm
Re: HUH? *NM*
daren neufeld -- 10/10/2001, 9:04 pm
Re: one 8"x10" please *NM*
LeeG -- 10/10/2001, 8:06 pm
Re: Aah Baloney :(
Roger Nuffer -- 10/10/2001, 7:05 pm
Outstanding! *NM*
Pete Rudie -- 10/10/2001, 6:25 pm
Re: First Stripper - Finally Launched
LisaS -- 10/10/2001, 6:13 pm
Re: First Stripper - Finally Launched
Mike Snell -- 10/10/2001, 6:07 pm
Challenges and Solutions
Ted Henry -- 10/10/2001, 7:12 pm
Re: First Stripper - Finally Launched
100GRIT -- 10/10/2001, 6:05 pm
thats a fine looking boat and the web page is kill *NM*
erez -- 10/11/2001, 5:09 pm
Re: First Stripper - Finally Launched
Ted Henry -- 10/10/2001, 8:05 pm
Re: First Stripper - Finally Launched
Ben Staley -- 10/10/2001, 5:54 pm
!!Super Nice Job Ted!! *NM*
Chip Sandresky -- 10/10/2001, 5:30 pm