Boat Building Forum
Find advice on all aspects of building your own kayak, canoe or any lightweight boats
Strip: Best Place For Form Positions *Pic*
By:Bobby Curtis
Date: 12/6/2001, 10:25 am
Date: 12/6/2001, 10:25 am
For stripping a symmetrical hull is it important to place the edge of the plywood form where each section is positioned? Or is it OK to center the form at each position? If the edge is needed I assume opposite edges are used for sections left or right of the center form.
Bobby
Messages In This Thread
- Strip: Best Place For Form Positions *Pic*
Bobby Curtis -- 12/6/2001, 10:25 am- Re: Strip: Best Place For Form Positions
Bobby Curtis -- 12/7/2001, 8:03 am- hehehe
mike allen ---> -- 12/6/2001, 7:48 pm- OFF TOPIC: Mech Eng/Physics modelling
Chris Menard -- 12/7/2001, 7:30 am- Nice! *NM*
Bill Price -- 12/6/2001, 11:41 pm - Nice! *NM*
- Re: Strip: Best Place For Form Positions
mike allen ---> -- 12/6/2001, 12:44 pm- Re: Strip: Best Place For Form Positions
Chip Sandresky -- 12/6/2001, 12:41 pm- Re: Strip: Best Place For Form Positions
Bill Price -- 12/6/2001, 11:50 am - hehehe
- Re: Strip: Best Place For Form Positions
