Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Sanding the inside *Pic*
By:Ross Leidy
Date: 1/8/2002, 9:46 am
In Response To: Strip: Sanding the inside (Stephan Bradley)

Although it's still by-hand, I've had good luck using a curved cabinet scraper on the interior. You've got to keep a good burr on the edge, but once you do, fairing the interior is not such a hard job. In fact, I kind of like it (to a point). After scraping, I use the foam block and sandpaper to give the surface some tooth, then I'm done.

Ross

Ross' kayaks

Messages In This Thread

Strip: Sanding the inside
Stephan Bradley -- 1/7/2002, 3:10 pm
Re: Strip: Sanding the inside *Pic*
Ross Leidy -- 1/8/2002, 9:46 am
Re: Strip: Sanding the inside
John Monfoe -- 1/8/2002, 4:26 am
Re: Strip: Sanding the inside
Dave Houser -- 1/8/2002, 2:08 am
Re: Strip: Sanding the inside
John Skinner -- 1/8/2002, 12:14 am
Re: Strip: Sanding the inside
Rehd -- 1/8/2002, 12:53 am
Re: Strip: Sanding the inside *Pic*
Tom Johansen -- 1/7/2002, 10:14 pm
Re: Strip: Orbital, Scraper and Hand
Rehd -- 1/7/2002, 9:18 pm
Re: Strip: Orbital, Scraper and Hand
Stephan Bradley -- 1/7/2002, 10:51 pm
Re: Strip: Orbital, Scraper and Hand
Rehd -- 1/8/2002, 12:56 am
Re: Strip: Sanding the inside
Myrl Tanton -- 1/7/2002, 3:39 pm