Myrl,

The magnets stay put just with resin. I found out how tough they were to remove when I had to replace a couple that corroded due to scratches in the resin surface coat. I now put a light layer of glass over the top in addition to the resin to prevent scratches.

: Hi Ted,

: You have it right, I should have one layer of glass over the top of the
: magnet. To keep the moisture off, and ensure it will stay put.

: I did not get my magnets today , I got to busy here at work, and could not
: race off at lunch. It will have to wait until Saturday.

: As for magnet size, I'm not sure, I want to re-check out the holding power. I
: currently think I'll go with the smaller ones. however I expect I may want
: a backup latching system. I was pretty excited about the twist lock gizmo
: that Chip was building, but Ross' method would leave the cover a little
: cleaner. we will see.

: For the magnets embedded in the hatch, will they hold with just epoxy to keep
: them in place, or should I have a single layer of glass over that as well?

: I tried a search earlier, but gave up to soon, I will re-try that.

: thanks

: Myrl