Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Epoxy: Edge delamination
By:JohnK
Date: 8/14/2008, 6:29 pm
In Response To: Re: Epoxy: Edge delamination (Brian Nystrom)

: After you strip the glass, wash the surface BEFORE sanding it. You want to
: remove the blush first, so you don't sand it INTO the epoxy.

Hi Brian,
I wondered about that, but it would be hard to wash a not smooth surface, so I suggested doing both steps in one. As I have not had to do this before, I don't know if that would work either, but it seems it should work.

Messages In This Thread

Epoxy: Edge delamination
Glen Gray -- 8/13/2008, 4:13 am
Re: Epoxy: Edge delamination
Glen Gray -- 8/16/2008, 9:21 am
Re: Epoxy: Edge delamination
JohnK -- 8/16/2008, 5:00 pm
Re: Epoxy: Edge delamination
JohnK -- 8/14/2008, 5:04 am
Re: Epoxy: Edge delamination
Brian Nystrom -- 8/14/2008, 8:11 am
Re: Epoxy: Edge delamination
JohnK -- 8/14/2008, 6:29 pm
Another option is...
Brian Nystrom -- 8/15/2008, 7:30 am
Re: Another option is...
Glen Gray -- 8/15/2008, 6:24 pm
Re: Epoxy: Edge delamination
JohnK -- 8/13/2008, 7:52 pm
Re: Epoxy: Edge delamination *Pic*
Glen Gray -- 8/14/2008, 3:48 am
Re: Epoxy: Edge delamination
Glen Gray -- 8/14/2008, 6:59 am
Re: Epoxy: Edge delamination *Pic*
Glen Gray -- 8/14/2008, 7:19 am
Re: Epoxy: Edge delamination *Pic*
Glen Gray -- 8/14/2008, 7:22 am
Re: Epoxy: Edge delamination
Bill Hamm -- 8/16/2008, 1:44 am
Re: Epoxy: Edge delamination
JohnK -- 8/14/2008, 6:22 pm