Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Strip: finish question
By:kirk briggs
Date: 11/19/2008, 8:37 pm

After I finish glassing my expedition single should I spray 2 part automotive urethane clear or just use varnish? I work in a bodyshop so I can hang and spay my kayak.Then bake it ,let it cool then it is done.Sonds so much easyer than varnish. Has anyone tried this and how does it work on a kayak and repair with wood?

Messages In This Thread

Strip: finish question
kirk briggs -- 11/19/2008, 8:37 pm
Cost?
Brion -- 11/23/2008, 9:45 pm
Auto Clear Coat-Yes *Pic*
Roger Turgeon -- 11/22/2008, 12:21 pm
Another Pic *NM* *Pic*
Roger Turgeon -- 11/22/2008, 12:24 pm
One More *NM* *Pic*
Roger Turgeon -- 11/22/2008, 12:29 pm
Re: One More
PatrickC -- 11/22/2008, 10:42 pm
Re: Strip: finish question
Mike Bielski -- 11/20/2008, 1:30 pm
Re: Strip: finish question
Bill Hamm -- 11/21/2008, 10:12 am
Do NOT bake!
Dan Caouette (CSFW) -- 11/20/2008, 3:30 pm
Re: Do NOT bake!
kirk briggs -- 11/20/2008, 6:23 pm
A big YES to Auto Clear Coats *LINK* *Pic*
Dan Caouette (CSFW) -- 11/20/2008, 7:36 am
Re: A big YES to Auto Clear Coats
danp -- 11/20/2008, 9:16 am
Re: A big YES to Auto Clear Coats
Dan Caouette (CSFW) -- 11/20/2008, 10:08 am
Re: Strip: finish question
Todd Sullivan -- 11/19/2008, 8:47 pm
Re: Strip: finish question
kirk briggs -- 11/19/2008, 8:51 pm
Re: Strip: finish question *LINK*
Glen Smith -- 11/19/2008, 9:11 pm