Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Epoxy: filling the weave inside the hull?
By:Clayton Plunkett
Date: 7/31/2009, 7:53 am
In Response To: Epoxy: filling the weave inside the hull? (uga_danny)

: I glassed the inside of the hull today, but I'm not sure if I should
: fill-the-weave tomorrow. My CLC manual says to, but Nick's book says there
: is no need.
: What should I do?
: thanks

I always use just one very light coat after glassing. This ensures that all pin holes are filled and smoothes the texture slightly. Good luck

Messages In This Thread

Epoxy: filling the weave inside the hull?
uga_danny -- 7/30/2009, 11:45 pm
Re: Epoxy: filling the weave inside the hull?
Deano -- 8/6/2009, 5:22 pm
Re: Epoxy: filling the weave inside the hull?
jeff mcgee -- 8/1/2009, 1:09 am
Filling the foot area in the hull?
Jay Babina -- 8/2/2009, 9:21 am
Re: Filling the foot area in the hull?
Robert N Pruden -- 8/4/2009, 9:36 am
Re: Filling the foot area in the hull?
Bill Hamm -- 8/5/2009, 12:30 am
Re: Epoxy: filling the weave inside the hull?
JEM -- 7/31/2009, 9:16 am
Re: Epoxy: filling the weave inside the hull?
uga_danny -- 7/31/2009, 1:44 pm
Re: Epoxy: filling the weave inside the hull?
uga_danny -- 7/31/2009, 1:50 pm
Re: Epoxy: filling the weave inside the hull?
Robert N Pruden -- 7/31/2009, 8:48 am
Re: Epoxy: filling the weave inside the hull?
Clayton Plunkett -- 7/31/2009, 7:53 am
Re: Epoxy: filling the weave inside the hull?
Duane Strosaker -- 7/31/2009, 12:47 am