The very best info on steam bending is...
By:Bruce Haugen
Date: 10/9/2002, 11:35 pm
Date: 10/9/2002, 11:35 pm
In Response To: Tools: Heat Gun temperature? (Terry Hanson)
http://www.leevalley.com/wood/page.asp?page=31161&category=1,45866,45867&abspage=1&ccurrency=2&SID=
You'll have to cut and paste, I think. This is the instruction book on steam bending from Lee Valley Tools and is widely regarded in the woodworking community as the best source on steam bending info.
Bruce
Messages In This Thread
- Tools: Heat Gun temperature?
Terry Hanson -- 10/9/2002, 11:47 am- Re: Tools: Heat Gun temperature?
Rob Macks -- 10/10/2002, 9:30 am- The very best info on steam bending is...
Bruce Haugen -- 10/9/2002, 11:35 pm- Re: The very best info on steam bending is...
Rick Allnutt -- 10/10/2002, 10:22 am- I second that!
Kent LeBoutillier -- 10/10/2002, 6:24 am - I second that!
- Re: Tools: Heat Gun temperature?
Rick Allnutt -- 10/9/2002, 1:43 pm- Re: Bending Spruce *Pic*
Mike Hanks -- 10/9/2002, 5:39 pm- Re: Bending Spruce
West -- 10/9/2002, 6:33 pm- Re: Bending Spruce
Mike Hanks -- 10/9/2002, 9:18 pm- Re: Bending Spruce
West -- 10/9/2002, 11:04 pm- Re: Bending Spruce
Mike Hanks -- 10/10/2002, 2:29 am- and that link is - - - -
West -- 10/9/2002, 11:06 pm - and that link is - - - -
- Spruce Goose
Tom -- 10/9/2002, 10:40 pm- Re: Spruce Goose
Mike Hanks -- 10/10/2002, 2:39 am- Re: Spruce Goose
Simon Baillie -- 10/12/2002, 12:55 pm
- Re: Spruce Goose
- Re: Bending Spruce
- Re: Bending Spruce *Pic*
John Michne -- 10/9/2002, 7:12 pm- Re: Bending Spruce
West -- 10/9/2002, 8:46 pm
- Re: Bending Spruce
- Re: Bending Spruce
- Re: Bending Spruce
- The very best info on steam bending is...
- Re: Tools: Heat Gun temperature?