Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Material: Vacuum-bvagging the hull?
By:Darren
Date: 2/14/2008, 5:44 am
In Response To: Re: Material: Vacuum-bvagging the hull? (Bill Hamm)

Hi,

Thanks for those couple of replies so far.

Apologies for not being able to spell "bagging":-)

I'll check out the web for the products and techniques mentioned and hope to give it a go when I get that far.

I need to look into peel ply too, have seen that used with both good and bad results so not 100% sold on it yet.

Regards,
Darren

Messages In This Thread

Material: Vacuum-bvagging the hull?
Darren -- 2/13/2008, 9:07 pm
Re: Material: Vacuum-bvagging the hull?
Acors -- 2/20/2008, 9:11 pm
Re: Material: Vacuum-bvagging the hull?
Darren -- 2/23/2008, 4:33 am
Re: Material: Vacuum-bvagging the hull?
Etienne Muller - Ireland -- 2/23/2008, 11:41 am
Re: Material: Vacuum-bvagging the hull?
Bill Hamm -- 2/26/2008, 2:39 am
Re: Material: Vacuum-bvagging the hull?
Acors -- 2/25/2008, 11:06 am
Re: Material: Vacuum-bvagging the hull?
Brian White -- 2/16/2008, 3:25 am
Re: Material: Vacuum-bvagging the hull?
JohnK -- 2/15/2008, 5:39 pm
Re: Material: Vacuum-bvagging the hull?
Paul G. Jacobson -- 2/14/2008, 12:27 pm
Re: Material: Vacuum-bvagging the hull?
Bill Hamm -- 2/14/2008, 1:54 am
Re: Material: Vacuum-bvagging the hull?
Darren -- 2/14/2008, 5:44 am
Re: Material: Vacuum-bvagging the hull?
Paul Hansen -- 2/20/2008, 3:07 am
Re: Material: Vacuum-bvagging the hull?
Bill Hamm -- 2/21/2008, 1:23 am
Re: Material: Vacuum-bvagging the hull?
PatrickC -- 2/13/2008, 10:33 pm