Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: the chines
By:Bill Hamm
Date: 9/19/2009, 8:28 am
In Response To: Strip: the chines (victor druten)

: Okay...I'm one strip away (On the middle forms) from ....argghhhh..the Hull
: CHINES. that is one big BEND on the Night Heron.
: Yeh, I could bevel that strip (or two)...but I have an idea I might try. I
: have these 1/4" dowels ( 3' long)that I've been using in the coves
: with my clamps ( NO GLUE so far)...to avoid crushing the cove ends. works
: super. THinking...about...at the chines...I LEAVE the dowels in and
: then...REVERSE the next strip to COVE DOWN. It looks..repeat..looks like
: it might work. It actually makes a kind of HINGE thing. Plus, it's a nice
: little 1/4" stripe also. figure that after the keel strips are
: in...they will have the coves facing down...and I could for a few
: pieces....alternate keel/sides until I have to bevel both sides.
: curious if anyone has done something like this???

I used 3/8" wide strips on the very tight corner on the chines of my Disko Bay, narrow strips make the chines easy, ok easier :)

Bill H.

Messages In This Thread

Strip: the chines
victor druten -- 9/14/2009, 5:59 pm
Re: Strip: the chines
Bill Hamm -- 9/19/2009, 8:28 am
Re: Strip: the chines
Malcolm Schweizer -- 9/15/2009, 3:24 pm
Re: Strip: the chines
Wesley Ewell -- 9/15/2009, 12:17 pm
Re: Strip: the chines
Deano -- 9/15/2009, 10:36 am
Re: Strip: the chines
Peter Sebbage -- 9/15/2009, 8:14 am