Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Skin-on-Frame: Floor boards? *LINK* *Pic*
By:barry boyette
Date: 9/27/2009, 2:16 pm
In Response To: Skin-on-Frame: Floor boards? (Kudzu)

: Just looking for anyone's experience with floors in a plywood framed SOF type
: boat. Had someone inquire about putting in floor boards. I am starting a
: new design, a touring boat and I think it would be great addition. This
: boat is stable enough the higher COG isn't going to be a an issue at all

: If you did this what material did you use for the floors. Cedar is light but
: hard to find here. Was thinking 1/4" plywood strips might be a good
: choice.
This is how I did mine. It's kind of the Yost way of doing it without using aluminum angles. I used some 5/8 plywood scraps and peg/epoxied them to the cross section and then peg/epoxied 1/4 oak bead board scraps that I had laying around. Later I coated them with epoxy and then varnished them.

I then drilled a couple of 1/4" holes and epoxied a couple of 3" dowels under the floor boards to keep them from sagging. I'm happy with them.
barryb

Messages In This Thread

Skin-on-Frame: Floor boards?
Kudzu -- 9/27/2009, 9:47 am
Re: Skin-on-Frame: Floor boards?
Ruedi -- 9/29/2009, 8:12 pm
Re: Skin-on-Frame: Floor boards?
Sean -- 9/29/2009, 9:14 pm
Re: Skin-on-Frame: Floor boards?
Bill Hamm -- 9/30/2009, 2:06 am
Re: Skin-on-Frame: Floor boards?
Bill Hamm -- 9/30/2009, 2:09 am
Re: Skin-on-Frame: Floor boards?
Bill Hamm -- 9/28/2009, 12:31 am
Re: Skin-on-Frame: Floor boards? *LINK* *Pic*
barry boyette -- 9/27/2009, 2:16 pm
What I meant was .....
Kudzu -- 9/27/2009, 10:07 pm
Re: What I meant was .....
Brian Scarborough -- 9/27/2009, 10:50 pm
Re: What I meant was .....
barry boyette -- 9/27/2009, 10:26 pm
Re: What I meant was .....
Kudzu -- 9/28/2009, 8:54 am
Re: What I meant was .....
Sean -- 9/28/2009, 11:28 pm
Re: What I meant was .....
Kudzu -- 9/29/2009, 1:03 pm
Re: What I meant was .....
Bill Hamm -- 9/30/2009, 2:04 am
Re: What I meant was .....
Sean -- 9/28/2009, 11:30 pm