Date: 8/31/1998, 2:18 pm
> Tom,
> I was sitting aroung this am drinking coffee and discussing our upcoming
> winter boatbuilding project with my wife Judy (see "cloning a
> boat" thread). One of the things I want to change when I copied the
> Tesla was to extend the stern further down and put in an integral rudder.
> I didn't like the ones I had seen where the rudder was at the keel because
> it seemed too fragile when doing rough landings to possibly be hitting a
> rock with this unprotected movable part.
> I had a preliminary image in my mind of a rudder halfway down the stern
> and was trying to describe what it would look like to Judy but I wasn't
> doing a very good job. I was quite pleased when I checked in on Nicks page
> and saw this thread. What you came up with was close what I had envisioned
> and was trying to describe, nice job.
> One question, I think you said there was a removable deck section to allow
> access to the rudder cables. How do you hold this removable section on the
> boat?
> Thanks for filling in the blanks for me...
> Edgar
Edgar,
The stern deck section that is removeable mates with the hull's sheer line. A horizontal bulkhead placed below the the hull's sheer line is used to hold the control cables rotating "T". Along the centerline of this bulkhead,I drilled holes for and bonded two 3/8 bronze bolts vertically that protrude through the upper deck section just enough so bronze cap nuts can be used to hold down the deck. The cap screws need be only finger tight so no tools are needed for removal/adjustment. (Hope this helps. Trying a description, again... if not clear, I'll send a picture)
Tom
![](http://www.quest4.com/rudiag.jpg)
Messages In This Thread
- integral rudder...again
Tom Scheibe -- 8/24/1998, 7:03 pm- Re: integral rudder... another question
Edgar Kleindinst -- 8/30/1998, 12:01 am- Re: integral rudder... another question
Nick Schade -- 8/31/1998, 5:51 pm- Re: integral rudder... another question
Edgar Kleindinst -- 9/4/1998, 5:29 pm
- Re: integral rudder... another question
Tom Scheibe -- 8/31/1998, 2:18 pm- Re: integral rudder... another question
Joe Greenley -- 8/29/1998, 2:21 pm- Re: integral rudder... Dagger Atlantis
Mark Kanzler -- 8/31/1998, 12:07 am- Re: integral rudder on Dagger Sitka
Ross Leidy -- 9/1/1998, 1:54 pm
- Re: integral rudder on Dagger Sitka
- Re: integral rudder... another question
- Please describe control cables
Pete Ford -- 8/25/1998, 7:47 pm- Re: Please describe control cables
Tom Scheibe -- 8/25/1998, 11:23 pm- Re: Please describe control cables
Mark Bodnar -- 8/26/1998, 6:03 pm- Re: Please describe control cables
Tom Scheibe -- 8/27/1998, 4:29 pm- Re: Please describe control cables
Mark Kanzler -- 8/27/1998, 6:55 pm- Re: Please describe control cables
Nolan Penney -- 8/28/1998, 6:49 am
- Re: Please describe control cables
- Re: Please describe control cables
- Re: Please describe control cables
- Re: Please describe control cables
- Re: integral rudder...again
Nolan -- 8/25/1998, 6:46 am- Re: integral rudder...again
Tom Scheibe -- 8/25/1998, 4:36 pm- Re: integral rudder...again
Tom Scheibe -- 8/25/1998, 5:11 pm- Re: integral rudder...again
Nolan Penney -- 8/26/1998, 6:31 am- Re: integral rudder...again
Tom Scheibe -- 8/26/1998, 2:30 pm- Re: integral rudder...again
Nolan Penney -- 8/26/1998, 3:06 pm- Re: integral rudder...again
Mark Kanzler -- 8/28/1998, 12:07 am- Re: integral rudder...again
Nolan Penney -- 8/27/1998, 3:19 pm- Re: integral rudder...again
Mark Kanzler -- 8/27/1998, 7:09 pm- Re: integral rudder...again
Nolan Penney -- 8/28/1998, 7:05 am- Re: integral rudder...again
Mark Kanzler -- 8/28/1998, 11:08 am- Re: integral rudder...again
Nolan Penney -- 8/28/1998, 3:14 pm- Re: integral rudder...again
Mark Kanzler -- 8/29/1998, 10:55 am
- Re: integral rudder...again
- Re: integral rudder...again
Mark Kanzler -- 8/28/1998, 10:59 am- Re: integral rudder...again
Nolan Penney -- 8/28/1998, 3:24 pm- Re: integral rudder...again
Mark Kanzler -- 8/29/1998, 11:10 am- Re: integral rudder...again
chris_rolt -- 8/28/1998, 7:14 pm- Re: integral rudder...again
Mark Kanzler -- 8/29/1998, 11:34 am
- Re: integral rudder...again
- Re: integral rudder...again
Mark Kanzler -- 8/28/1998, 11:49 am - Re: integral rudder...again
- Re: integral rudder...again
- Re: New BBS Format
Mark Kanzler -- 8/27/1998, 7:14 pm - Re: integral rudder...again
- Re: integral rudder...again
- Re: integral rudder...again
- Re: integral rudder...again
- Re: integral rudder...again
- Re: integral rudder...again
- Re: integral rudder...again
- Re: integral rudder...again
Mark Kanzler -- 8/25/1998, 4:49 pm - Re: integral rudder...again
- A Picture - Rudder on a Cobra Kayak
Tom W. -- 8/25/1998, 3:19 pm- Re: A Picture - Rudder on a Cobra Kayak
Mark Kanzler -- 8/25/1998, 3:55 pm
- Re: integral rudder...again
John Lange -- 8/25/1998, 1:01 pm- Re: Dagger Sitka Link
Mark Kanzler -- 8/25/1998, 3:52 pm- Re: Dagger Sitka Link
John Lange -- 8/25/1998, 4:25 pm- Re: Dagger Sitka Link
Mark Kanzler -- 8/25/1998, 4:37 pm- Re: 24' x 26"??
Wynne -- 8/27/1998, 3:04 pm- Re: 24' x 26"??
Mark Kanzler -- 8/27/1998, 7:21 pm
- Re: 24' x 26"??
- Re: 24' x 26"??
- Re: Dagger Sitka Link
- Re: Dagger Sitka Link
- Re: integral rudder...again
Mark Kanzler -- 8/25/1998, 10:55 am - Re: integral rudder...again
- Re: Flow tank testing.
Mark Kanzler -- 8/24/1998, 8:37 pm - Re: integral rudder... another question
- Re: integral rudder... another question